3G biometric attendance devices.
Why the battery powered 3G biometric attendance
devices.
Only All-IN-One
solution for battery powered 3G/4G wireless biometric attendance devices with
built in battery and battery panel. Easy
to install biometric attendance devices with just two screws, can work in wild
field anywhere with the sunshine. Water proof
& weather proof wireless biometric attendance devices, can work without
charging for 32 hrs and in cloudy & rainy day 20 hrs every day. Work full
day & night when the sunshine temp is above 33C. 3G/4G biometric attendance system application
water proof can use anywhere has 3G/4G
network, with AP mode for easy wifi
setting up. Megapixel, starlight sensor biometric
attendance devices to work great in the night,
Lens Sensor: 0.0001LUX(Starlight Level). Night vision distance 100m.
Detailed
biometric attendance devices specifications.
i.
One can install this All-in-one Battery biometric
attendance devices in anywhere with 3G/4G signal in the wild field with just 2 screws.
Easy!
ii.
System Employee: Supports three-level account
Onvif Protocol: support Onvif 2.1
Onvif Protocol: support Onvif 2.1
iii.
On PC:
support remote multi-devices monitor, record, alarm,
etc
support iPhone, Android Smartphone
Battery Power: When No Sunshine, the battery can work for 32 hours ( After Full 8 hours charge)
Rainy / cloudy, the battery can work 20 hours every day.
support iPhone, Android Smartphone
Battery Power: When No Sunshine, the battery can work for 32 hours ( After Full 8 hours charge)
Rainy / cloudy, the battery can work 20 hours every day.
iv.
The temperature of the light upper than 33°C, the battery can work Continuously
TF Card Record: Built-in 16GB TF card, Max 128G support.
Support Battery Power and Battery24AH?
Lens Sensor : 0.0001LUX(Starlight Level)
TF Card Record: Built-in 16GB TF card, Max 128G support.
Support Battery Power and Battery24AH?
Lens Sensor : 0.0001LUX(Starlight Level)
v.
Image Compression: H.264/MJPEG, Sensor 1/four
CMOS 1.0 Megapixel
Symbol Frame Rate: 50Hz:25fps/60HZ:30fps (1280×720)
First Stream: 720P-(1280x720), (640x352)
Second Stream: VGA-(640x352), (320x176)
Symbol Frame Rate: 50Hz:25fps/60HZ:30fps (1280×720)
First Stream: 720P-(1280x720), (640x352)
Second Stream: VGA-(640x352), (320x176)
vi.
Support 4 Independent detection
areas(Sensitivity can be adjustd 1-100?
Motion Detect: support Email Photo Alert, Snapshot and Record uploaded to FTP
Network Ethernet Interface: One 10/100Mbps RJ-45
Motion Detect: support Email Photo Alert, Snapshot and Record uploaded to FTP
Network Ethernet Interface: One 10/100Mbps RJ-45
vii.
Supported Protocol:
TCP/IP,HTTP,TCP,ICMP,UDP,ARP, IGMP, SMTP, FTP, DHCP, DNS, DDNS,NTP,UPNP,RTSP
IP Mode: Dynamic IP , static IP deal with, PPPOE
IP Mode: Dynamic IP , static IP deal with, PPPOE
viii.
Support
3G/4G connection:
ix.
TD-SCDMA:
Support 4G(B38/B39/B40/B41),3G?B34/B39),2G(900/1800MHZ)
x.
WCDMA:
Support 4G(B1/B3/B5),3G(B1),2G(900/1800MHZ)
xi.
CDMA2000: Support 4G(B1/B3/B5)
xii.
Wifi: WIFI,802.11 b/g/n
xiii.
WIFI Frequency: 2400~2483.5MHZ
xiv.
WIFI Employee: WEP?WPA-PSK,WPA2-PSK,WPA-WPA2 mixed
xv.
WIFI Users:
Max support 9 users
xvi.
TD-SCDMA :Support
4G(B38/B39/B40/B41),3G?B34/B39),2G(900/1800MHZ)
WSCDMA : Support 4G(B1/B3/B5),3G(B1
WSCDMA : Support 4G(B1/B3/B5),3G(B1
Installation
strategy
i.
Far exterior view


ii.
Far range interior view


iii.
Mid- range interior view


iv.
Close range interior view


v.
Control room
There shall be a
control room, with a single workstation,
manning all the biometric attendance devicess. It shall be located in the opposite direction, similar position to the
changing rooms.

i.
iv. alerts and response and voice command.
It
shall be included, which shall serve as a mass
announcement and alarm response, both controlled from the control room.
Comments
Post a Comment